www.merging.com/horus Page 2 - 7
HORUS FIRMWARE
Make sure that you are running the latest certified firmware:
http://www.merging.com/horus/download
Verify your Horus firmware version by going to the Horus Setup menu and open the System info page
to verify the firmware version installed.
Refer to the Horus User Manual Firmware Update section in order to proceed with a Firmware
update.
Note: There are two types of Horus updates possible. Either the Horus Firmware update (frequent
releases) or the Maintenance Mode update (un-frequent releases but mandatory for some firmware).
CURRENT LIMITATIONS (Firmware)
Latest Firmware limitations:
RAVENNA redundancy is not yet implemented
MIDI/RS422/BiPhase/GPIO not yet implemented
DSD (refer to Horus User Manual for precise details)
o No VU meters
The limitation list above will be progressively reduced with firmware updates.
Notes:
- Supported sync: RAVENNA (PTP slave), Wordclock, Video sync, AES input and MADI input
- Sync Source known issue: LTC input is accurate up to 10x nominal speed (applies to early
Horus production only)
FIRMWARE UPDATES HISTORY
Fixed in Firmware version 20795:
For Horus DXD & DSD support in RAVENNA. The Pyramix users must upgrade to Pyramix v8.1
Fixed: RAVENNA ASIO, current sample rate report accuracy issue
Fixed in Firmware version 20622:
Fixed: LTC output potential missing frame
Fixed: Remove Error messages (Fifo and Buffering)
Fixed: inaccurate power Supply error message when connected to secondary only
Fixed. Horus not working with certain Hirschipsmann switches (MAR1140) due to too severe
Ethernet preamble check
Fixed in Firmware version 20417:
For Horus DXD & DSD support in RAVENNA. The Pyramix users must upgrade to Pyramix v8.1
Beta3
Improvement: AD Premium Mic pre-amp DSD gain range of 0dB to +60dB
Improvement: Format page: DSD/DXD GUI clarification
Improvement : Limiter added to avoid noise when overloading input in DSD
Fixed. Horus monitor jack provides the same channel on both outputs (8FS only)
Fixed. Phase invert now working in DSD
Fixed in Firmware version 20084:
For Horus DXD & DSD support in RAVENNA. The Pyramix users must upgrade to Pyramix v8.1
Beta2
Improvement: DSD256 noise floor improvement
Improvement: DSD256 removed DC offset
Improvement: DSD64 and DSD128 support
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern